Chemical Anchor

Technical data at 20 ºC and 60 %RV

Surface Preparation
Drill holes to the correct diameter and depth (see chart for guide), ideally using a pneumatic drill. Better not use diamond drills because of lack of adhesion. For optimum results the hole must be coarse sided. Remove dust and debris from the hole using a hand air pump or a stiff rotary brush. All bars should be clean and free from oil or grease and all flaking rust should be removed. Threaded rod or studs should be chisel-ended to prevent them being unscrewed from the cured resin.

Application
Unscrew the lid and cut off the metal clamp from the bag. Attach the mixing nozzle to the cartridge (screw down hand tight). Place cartridge into the dispensing gun. Gradually pressurise the cartridge by activating the hand trigger a few times until material passes through the mixing nozzle and an even colour is obtained (approximately 5-6 inches of extruded material should be adequate). Once the desired fill is achieved release the pressure by pressing the slide release arm and pulling back the slide rail, wipe off excess material and insert the fixing slowly, with a rotating action, to the desired depth.

Limitations

• Do not use in non-porous substrates i.e. metal, PVC.
• Do not use on wet surfaces.
• As the manufacturer cannot know all the uses its product may be put to, it is the users responsibility to determine suitability for use.
• If in doubt, contact technical services department for advice.

Packing
Cartridges 300 ml.

Storage and use
Store dry and cool between +5°C and +25°C, in its original sealed packing. Use best before 12 month after production.

Health & Safety
Avoid long lasting contact with skin. In case of contact with the eyes, rinse with plenty of water and consult a doctor. Avoid any contact with food as long as the product is not fully cured. Keep away from children. The product is not hazardous when applied properly and correctly. Material Safety Data Sheets (MSDS) can be obtained upon request.